Troubleshooting - Kicker NISSAN Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

Speaker will not turn on:
• Hold the Power button.
• Make sure that the power cord has been plugged directly into a known-good wall outlet.
• Press the reset button inside the hardware panel using a paperclip or safety pin.
Bluetooth device will not connect:
• On your mobile device:
• Turn Bluetooth off, then on again.
• Remove 'NISSAN TG AUDIO' from the Bluetooth menu. Then pair again (see page 7).
• Move your mobile device closer to the speaker. Avoid obstacles that may block the wireless signal.
• If problems persist, follow the directions below to factory reset the speaker.
Double-Kick Mode will not engage Primary/Secondary:
• Follow the instructions to manually enter Double-Kick Mode on page 7.
• If problems persist, follow the directions below to factory reset both Primary and Secondary speakers.
No Sound:
• Turn the speaker off, then back on again.
• Press the Pair button until the status LEDs show the correct input mode. Blue = Bluetooth; Red = FM;
Green = AUX.
• Increase the volume on the speaker and on the mobile device.
• Check that music is playing on the mobile device.
• If problems persist, follow the directions above to factory reset the speaker.
Bluetooth Mode:
• Check that the status LED is solid blue.
• Open the Bluetooth menu on the mobile device, and check that 'NISSAN TG AUDIO' shows
connected.
• Begin playing music on mobile device. Set audio output to Bluetooth.
• Move your mobile device closer to the speaker. Avoid obstacles that may block the wireless signal.
FM Mode:
• Check that the status LED is solid red.
• Push PLAY/PAUSE button to ensure speaker is not muted.
• Use the KICKER Connect App to tune into a stronger FM station.
AUX Mode:
• Check that the status LED is solid green.
• Begin playing music on mobile device. Set audio output to headphones.
• Push PLAY/PAUSE button to ensure speaker is not muted.
• Ensure the 3.5mm AUX cable is fully plugged into the LINE IN connector of the speaker's side
hardware panel. Make sure the cable is not plugged into the ANTENNA connector.
• The 3.5mm AUX cable may be bad. Try a new cable.
KICKER Connect cannot connect to the Nissan Tailgate Audio by KICKER:
• Confirm mobile device compatibility. You must be running iOS 8.0 or Android 4.3 and newer.
• Check that the speaker is turned on and charged.
• Only one mobile device may be connected to the speaker at a time. Check that a 2nd device is not already
connected.
• Restart the mobile device, and try again.
Portable device will not charge from the USB port:
• Check that the speaker is turned on.
• Check that speaker is charged by attaching a power cord to the speaker.
• Check that you are using a known-good charge cable.
• Restart the speaker and the mobile device (if possible), and then try again.
FM reception is weak:
• Make sure you are using the KICKER Connect app to tune and save the strongest stations, or use the seek
buttons to find the strongest stations available.
• For best FM reception, place the speaker as high above the ground as possible.
• Avoid placing the speaker directly next to large objects that will block the sky, like buildings and trees.
• If you are indoors, use the external FM antenna provided. Test a variety of antenna positions to find the
best FM reception.
Factory Reset:
• Factory reset restores the dock back to the way it was shipped to you. This can be useful to reset the
equalizer and volume levels to default, and can help solve issues with Bluetooth, FM radio, or with the
KICKER Connect app. With the speaker turned on, press and hold the PLAY/PAUSE button for 10 seconds
until all LEDs turn off. This will reset all settings back to factory defaults, including Bluetooth settings and
paired device memory.
Hardware Reset:
• Hardware reset allows the speaker to recover from unexpected issues. If the speaker becomes
unresponsive, momentarily press the reset button on the side of the speaker using a paperclip.
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nieau

Tabla de contenido