Work Area Safety; Electrical Safety; Personal Safety - Deltafox DP-CRH 2011 Traducción Del Manual De Instrucciones Original

GB

1) WORK AREA SAFETy

a) Keep work area clean and well lit.
Cluttered or dark areas invite acci-
dents.
b) Do not operate power tools in ex-
plosive atmospheres, such as in
the presence of flammable Iiquids,
gases or dust. Power tools create
sparks which may ignite the dust or
fumes.
c) Keep children and bystanders
away while operating a power tool.
Distractions can cause you to lose
control.

2) ELECTRICAL SAFETy

a) Power tool plugs must match the
outlet. never modify the plug in
any way. Do not use any adapter
plugs with earthed (grounded)
power tools. Unmodified plugs and
matching outlets will reduce risk of
electric shock.
b) Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and re-
frigerators. There is an increased
risk of electric shock if your body is
earthed or grounded.
c) Do not expose power tools to rain
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
d) Do not abuse the cord. never use
the cord for carrying, pulling or un-
plugging the power tool. Keep cord
away from heat, oil, sharp edges
or moving parts. Damaged or entan-
gled cords increase the risk of electric
shock.
e) When operating a power tool out-
doors, use an extension cord suit-
22
able for outdoor use. Use of a cord
suitable for outdoor use reduces the
risk of electric shock.
f) If operating a power tool in a
damp location is unavoidable, use
a residual current device (RCD)
protected supply. Use of an RCD
reduces the risk of electric shock.

3) PERSOnAL SAFETy

a) Stay alert, watch what you are do-
ing and use common sense when
operating a power tool. Do not use
a power tool while you are tired
or under the influence of drugs,
alcohol or medication. A moment
of inattention white operating power
tools may result in serious personal
injury.
b) Use personal protective equip-
ment. Always wear eye protection.
Protective equipment such as dust
mask, non-slip safety shoes, hard
hat, or hearing protection used for
appropriate conditions will reduce
personal injuries.
c) Prevent unintentional starting. En-
sure the switch is in the off-position
before connecting to power source
and/or battery pack, picking up
or carrying the tool. Carrying power
tools with your finger on the switch or
energising power tools that have the
switch on invites accidents.
d) Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the