Initial Start-Up; Checking The Battery Charge Level; Inserting/Removing The Device's Battery Pack; Selecting A Tool - Deltafox DP-CRH 2011 Traducción Del Manual De Instrucciones Original

GB
Warning! Observe the safety
information in the operating
instructions for your
DELTAFOX 20 V Li-Ion series
rechargeable battery.

Initial start-up

Place the rotational direction
switch into the central position be-
fore carrying out any work with the
electrical tool (e.g. maintenance,
change of tool etc.), as well as
during transportation and storage.
There is a risk of injury if the on-off
switch is accidentally activated.
Checking the battery charge
level
The battery's (
indicated by the charge state indicator
( 10).
The LEDs indicate the battery's charge
level. To do this, press and hold the
charge level indicator (
battery ( 9) .
red-yellow-green => Battery fully
red and yellow => Battery half charged
red => Battery needs
Inserting/removing the device's
battery pack
Inserting the battery pack:
• Push the rotational direction switch
( 6) into the central position
(locked). Allow the battery pack (
to latch into the handgrip.
26
9) charge level is
10a) on the
charged
to be charged
Removing the battery pack:
• Press the button (
and remove the battery pack (

Selecting a tool

An SDS Plus attachment tool is required
for impact drilling.
Use the keyless chuck with SDS Plus
adapter for drilling without impact into
wood, metal, ceramic and plastic.
You can insert cylindrical drill bits with a
diameter of 0.5 - 10 mm into this chuck,
or an attachment tool with a hexagonal
shaft.
For screwing, use the screw bits that are
inserted via the bit adapter with SDS Plus
adapter.
The "impact drilling" operating
mode may only be used if the key-
less chuck is not attached!

Changing the tool

The tool holder with SDS Plus adapter al-
lows you to change the attachment tool
easily and conveniently without use of
additional tools.
The attachment tool is freely movable for
technical reasons. This causes a concen-
tricity deviation during idling but this has
no effect on the accuracy of the bore hole
since the drill centres itself automatically
while drilling.
The device is capable of using various
drill bit types featuring a hexagonal or cy-
9) lindrical shaft thanks to the keyless chuck
with SDS Plus adapter.
9a) to unlock
9).