Qilive Q.6594 Manual De Instrucciones página 32

EN
Problems
Dishwasher
doesn't
start.
Water not
pumped
from
dishwasher
Suds
remaining
in the tub.
Stained tub
interior.
Possible
causes
Fuse blown
or the circuit
breaker is
tripped
Power supply is
not turned on.
Water pressure
is low.
The dishwasher
door is not
closed properly.
Twisted or
trapped drain
hose.
Filter clogged.
Kitchen sink
clogged.
Wrong
detergent.
Spilled rinse-aid.
Detergent with
a colourant may
have been used.
What to do
Replace the fuse or reset the circuit breaker.
Remove any appliances sharing the circuit with
the dishwasher.
Make sure the dishwasher is turned on and the
door is closed securely. Make sure the power
cord is plugged into the wall socket.
Check that the water supply is connected
properly and the water is turned on.
Make sure to close the door properly and latch
it.
Check the drain hose.
Check the coarse filter.
Check the kitchen sink to make sure it is
draining well. You may need a plumber.
Use only dishwasher detergents to avoid excess
suds. If suds remain, or excess suds occur,
open the dishwasher and let the suds subside.
Add 1 gallon of cold water to the bottom of the
dishwasher. Close the dishwasher and select
any cycle. Initially, the dishwasher will drain
the water. Open the dishwasher door, after the
water is drained, and check if the suds have
been cleared. Repeat if necessary.
Wipe up rinse-aid spills immediately.
Use only colourant-free detergents.
32