Moving The Appliance; Troubleshooting - Qilive Q.6594 Manual De Instrucciones

Spray arms – Clean the spray arms regularly (hard water chemicals will clog the
■
spray arm jets and bearings):
– Remove the upper spray arm: Hold the nut in the centre still. Rotate the spray
arm counterclockwise to remove it (Fig. V).
– Remove the lower spray arm: Pull out the spray arm upward (Fig. W).
– Wash the spray arms in soapy and warm water. Use a soft brush to clean the
jets. Reinsert the spray arms after rinsing them thoroughly (Fig. W).
8.4. FROST PRECAUTION
Take frost protection measures on the appliance in winter. Every time after washing
cycles, operate as follows:
■ Cut off the electrical power to the appliance at the supply source.
■ Turn off the water supply and disconnect the water inlet pipe from the water valve.
■ Drain the water from the inlet pipe and water valve.
■ Reconnect the water inlet pipe to the water valve.
■ Remove the filter at the bottom of the tub and use a sponge to soak up water.

8.5. MOVING THE APPLIANCE

If the appliance must be moved, try to keep it in the vertical position. If absolutely
necessary, it can be positioned on its back.

9. TROUBLESHOOTING

Warning:
■ If an overflow occurs, turn off the main water supply before calling for service.
■ If there is water in the base pan because of an overflow or a small leak, remove
the water before restarting the dishwasher.
If there is a malfunction, the dishwasher displays an error code.
Codes Meaning
Longer inlet
E1
time.
Not reaching
E3 required
temperature.
E4 Overflow.
Failure of
orientation of
E8
the distributary
valve.
Failure of
communication
Ed between the
main PCB and
the display PCB.
Possible Causes
Faucets not open, water intake is restricted, or
water pressure is too low.
Malfunction of the heating element.
Some element of the dishwasher leaks.
Open circuit or a break in the distributary valve.
Open circuit or a break in the wiring between
the two PCBs.
31
EN