Charging The Battery; Releasing The Battery; Inserting The Battery; Disposal Of The Battery - Seecode SHF 20 Manual De Instrucciones

5.2 Charging the battery

5.2.1 releasing the battery

.

5.2.2 inserting the battery

5.2.3 disposal of the battery

5.3 turning on the SeecodeWheel

Please charge the battery for at least 5 hours before the first
usage to prolong the battery life.
1. Push the two security locks inward to unlock the battery and
pull it out..
2. Connect the Mini USB part of the car charger with the
charging port at the side of the battery.
3. Connect the car charger with the cigarette lighter port.
The charging LED of the battery will be red during charging and
will go off when the battery is fully charged.
The SeecodeWheel can also be charged with a standard Mini
USB charging/data cable (not included) through the USB port of
a PC or Laptop.
1. Push the battery slot in the battery compartment.
2. The red label with "Frontside" on it must be facing you.
3. Push the two security locks outwards to secure the battery.
Dispose the battery according to the local regulations of your
country. Do not dispose as household waste.
Press for two seconds.
You will see a welcome note SEECODE , afterwards
SEECODE will indicate on the display when there is no
connection If you have paired your mobile phone in advance,
press , once to activate the auto search mode.
If there is no BT connection for over 5 minutes, the unit will
automatically switch off completely to save power.
12
ENGLISH