Warn TRANS4MER GEN II 80142 Instrucciones De Instalación

Your safety, and the safety of others, is very important. To help you make informed decisions about safety, we
have provided installation and operating instructions and other information on labels and in this guide. This
information alerts you to potential hazards that could hurt you or others. It is not possible to warn you about all
potential hazards associated with this product, you must use your own good judgment.
CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE. READ
AND UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BEFORE INSTALLING AND
OPERATING THIS PRODUCT.
This guide identifies potential hazards and has important safety messages that help you and others avoid personal
injury or death. WARNING and CAUTION are signal words that identify the level of hazard. These signal words mean:
WARNING signals a hazard that could cause serious injury or death, if you do not follow recommendations.
CAUTION signals a hazard that may cause minor to moderate injury, if you do not follow recommendations.
This guide uses NOTICE to call attention to important mechanical information, and Note: to emphasize
general information worthy of special attention.
Failure to observe these instructions could lead to equipment damage.
 Always use appropriate and adequate care in lifting components into place.
 Always insure components will remain secure during installation and operation.
 Always tighten all nuts and bolts securely, per the installation instructions.
I. TOOLS REQUIRED
3/16 ALLEN WRENCH
11/16" SOCKET
II. TORQUE SPECIFICATIONS
5/16 11 lb. ft. (14.9 N-m)
III. INSTALLATION DIAGRAM
Warn Industries Inc.
INSTALLATION INSTRUCTIONS
HEADLIGHT GUARD KIT
NOTICE
9/16" SOCKET
3/8 30 lb. ft. (40.7 N-m)
GASKET INSTALLATION DIAGRAM
PAGE 1
TRANS4MER GEN II
7/16 50 lb. ft. (67.8 N-m)
RATCHET
80332 Rev. A3