Nice INB Instrucciones Y Advertencias Para La Instalación página 3

BTicino
SCS
interface
My Home
INB
interface
INB
Table B
1
TTBus
+ (~)
BusT4
– (~)
L4 L3
2
BusT4
control unit
Nice
TTBus
motor 1
motor 2
motor 3
motor 4
BusT4
control unit 1
control unit 2
control unit 3
control unit 4
SCS
L2 L1
3
TTBus
+ (~)
motor 1
– (~)
motor 2
24V
(20 ÷ 35 Vdc 18mA;
22 ÷ 35 Vac 18mA)
• Configuration of INB for combination, within My Home, with the "Au-
tomation System"
The BTicino automation system envisages a routing process defined by "Group",
"Ambient" and "Lighting point". On the INB interface, the configurators set:
- "Ambient" (the ambient of the SCS system to which the interface belongs)
- "Group" (the group of the SCS system to which the interface belongs)
- "System" (identifies the Bticino system)
- "Bus Nice" (identifies the type of Nice bus connected)
The interface configuration is shown below. For a practical example, see fig. 4.
Configurator Description
A Ambient
- Do not use
GROUP Group
SYS SCS system
BUS Type of Nice bus used
On the My Home ® system, after "Systems", "Group", and "Ambient", the value of
"Lighting point" corresponds to the series of the device on the "TTBus", or the series
of the device on the "BusT4"; only values from 1 to 8 are admissible (each INB can
manage up to maximum 4 devices).
• Configuration of INB for combination, within My Home, with the "Video
door entry System"
On the video door entry system of BTicino the external point (actuator) is identified by
an address from 0 to 95. This address must coincide with the series of the Nice con-
trol unit. Values from 1 to 8 are admissible (each INB can manage up to maximum 4
devices).
The interface configuration is shown below. For a practical example, see fig. 5.
Configurator Description
A Do not use
- Do not use
GROUP Do not use
SYS SCS system
BUS Type of Nice bus used
• Configuration of INB for combination, within My Home, with the "Ac-
cess Control system"
On the access control system of BTicino the external point (actuator) is identified by
an address from 0 to 99. This address must coincide with the series of the Nice con-
trol unit. Values from 1 to 8 are admissible (each INB can manage up to maximum 4
devices).
Configurator value
1 ÷ 9
–––
1 ÷ 9
1: automation
0: TTBus / 1: BusT4
Value
–––
–––
–––
6: video door entry
1: BusT4
English – 2