Emptying The Recovery Tank; Cleaning The Appliance; Periodic Checks - Ghibli & Wirbel M9 Uso Y Mantenimiento

Emptying the recovery tank

- Position yourself over a floor drain with
the appliance.
- Detach the drain hose (38 Fig. 22) from
its relative support.
- Unscrew the knob (39 Fig. 22) and re-
move the cap (40 Fig. 22) of the water
drain hose (38 Fig. 22) and empty the
liquid into the recovery tank (41 Fig.23).
- When draining is complete reassemble
all the parts proceeding in the reverse or-
der
Daily cleaning
Checking and cleaning the polyester
filter (if present)
Release the levers (1 Fig. 1) and remove the
cover (2 Fig. 2) complete with motor.
- Remove the polyester (3 Fig. 3) filter
- Clean the filter (3 Fig. 24) from the in-
side out with a blast of air; the filter can
be washed (3 Fig. 24) in warm water and
must only be replaced once it is com-
pletely dry. If it is too dirty, replace it.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.

Cleaning the appliance

- Clean the unit body with a cloth damp-
ened with water or a mild detergent;
- Remove the cover as indicated previously
and clean the inside of the tank with run-
ning water, leaving the drain hose open
(38 Fig. 23) then reassemble everything
proceeding in reverse order.
DANGER:
Do not wash the appliance using jets of
water.
Cleaning the detergent dosing circuit
At the end of each workday, clean the de-
tergent dosing circuit as follows to prevent
clogging:
- Discharge the pressure from the circuit,
with the dosing pump switched off, the
lever (35 Fig. 21)
- Disconnect the detergent suction hose
(20 Fig.14).
- Remove the detergent container (26
Fig.25) lifting it by the dedicated handle
(42 Fig. 25).
- Empty the remaining liquid into a suitable
container.
- Wash the inside of the detergent contain-
er with running water.
- Put the detergent container back in place,
attaching it to the dedicated bracket (43
Fig. 25) fixed to the tank.
- Connect the detergent
suction hose to the quick coupling (21
Fig.14).
- Pour clean water into the detergent con-
tainer, electrically connect the appliance
and start the dosing pump by pressing
the switch (34 Fig.20).
- Clean the circuit by pressing the lever (35
Fig.21).
- Dispense the liquid from the nozzle until
clean water comes out.
- Empty the water in the detergent tank as
described above.

Periodic checks

Checking the air outlet filter
- Loosen the screws (44 Fig.26) and re-
move the cover (45 Fig.26)
- Remove the filter sponge (46 Fig.27) and
the wet sponges (47 Fig. 28).
- Clean the sponges with a blast of air
(Fig.29).
The filter sponges can be washed in
warm water and must only be replaced
once they are completely dry; if too dirty,
replace them with new ones.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
Cleaning the detergent dispensing
nozzle
If you note that the detergent is not dispensed
evenly, clean the nozzle as described be-
low:
EN - 9
EN
(20 Fig. 14)