Spare Parts - Ghibli & Wirbel M9 Uso Y Mantenimiento

EN IT
- Remove the ring nut (48 Fig. 30).
- Remove the nozzle (49 Fig. 30) and clean
it with running water, if it is clogged use a
pin being careful not to distort the shape
of the nozzle.
- Reassemble all of the parts performing
these operations in the reverse order.
Cleaning the detergent suction filter
If you note that the detergent is not being
suctioned properly, check and clean the suc-
tion filter located inside the detergent tank.
PROBLEM
The vacuum cleaner does
not work.
Suction is not satisfactory.
Detergent dispensing not
even
Detergent dispensing not
working
- Remove the tube (50 Fig. 31) from the
tank (26 Fig. 31)
- Remove the filter (51 Fig. 31) and wash it
under running water; if it is too clogged it
should be replaced.
- Reassemble all of the parts performing
these operations in the reverse order.
Single motor mod.
Pack of 10 paper filter bags Cod. 6830030
Polyester filter
CAUSE
Switch not pressed.
Plug not inserted.
No current.
Paper bag full.
Filter elements clogged.
Accessories or tubes
clogged.
Suction nozzle squeegee
worn or damaged.
Nozzle worn
Filter clogged
Switch not pressed
Thermal protection enabled
EN - 10

SPARE PARTS

Cod. 6730000
SOLUTION
Press the switch.
Insert the plug into the
socket.
Check the power
supply line.
Replace the dust bag.
Clean the filter elements.
Check and clean the
flexible hose and the
suction nozzle.
Check and replace the
squeegee
Clean nozzle
Clean the suction filter
Press the switch
Wait approx. 30 second for
automatic reset