Monacor JTS RU-901G3/5 Manual De Instrucciones página 13

A Settings for the receiver
Indication Setting function
20 dB attenuation of the level
at the XLR output (14)
ATT On =
attenuation activated, for
button connection of the XLR output to a

ATT
microphone input
The display shows ATT.ON
ATT OF = no attenuation, for connection to
button a line input

Key lock
to protect the receiver against inadvertent
switch-off or operation
Press the button
(LOCK ON shown on the display) and then
press SET to save. The symbol
LOCK
the display.
When a button is pressed, LocOn will be shown
on the display.
To deactivate the key lock, press the button SET
for 3 seconds until LOCK ON is shown on the
display, press the button
on the display) and then press SET to save.
B Settings for the transmitter
Indication Setting function
Microphone sensitivity to match the micro-
phone to the volume of the voice / instrument
Adjust the sensitivity according to the LED
indicators AF (6) in such a way that an opti-
mum signal level is obtained. If the sensitivity
SENSIT
is too high, the microphone signal will distort;
in this case, press the button
value (min. −15 dB). If the volume is too low,
there will be a poor signal-to-noise ratio; in this
case, press the button
(max. +15 dB).
Additional 20 dB attenuation
(only possible for model RU-G3TB/5) when high
microphone levels cause distortions
ATT
ATT OF = no attenuation (button
ATT On = attenuation activated (button
Transmission power (RF Power)
Use the button
power to Hi = high transmission power
(50 mW) for a long range, but a short battery
RF PWR
life or
use the button
to Lo = low transmission power (10 mW) for a
long battery life, but a short range
to activate the key lock

appears on
(LOCK OF shown

to set a lower

to set a higher value

)


to set the transmission

to set the transmission power

B Settings for the transmitter
Indication Setting function
Automatic switch-off
when the microphone is muted, to save the
batteries
AutoOF
Adjustable time: 1, 10, 30 minutes and
OFF (= no automatic switch-off)
REMOSET configuration
RC FRE =
button
RC FRE
RC ALL =
button
4.4 REMOSET function
For the REMOSET function, make sure that
1 the corresponding transmitter is switched
on; the distance between the transmitter
and the receiver is 10 – 50 cm The vertical
angular deviation with respect to the ultra-
sonic transmitter (2) of the receiver must not
exceed ±30°
−30° +30°
)
Fig. 3 Distance during REMOSET transmission
2 the receiver is not in the setting mode; the
menu is not called up on the transmitter
3 the display illumination is not red (= batteries
of the transmitter discharged)
To transfer settings from the receiver to the
transmitter: Press the button REMOSET (4); the
The REMOSET function will set the
transmitter only to the group and

the channel or the transmission
frequency of the receiver.
All settings will be transferred to
the transmitter.

RU-901G3/5
13