For Your Safety; Tool Specifications; Product Features; Starting Operation - Würth master AL 20-EMC Traducción Del Manual Original

AL 20-EMC - Buch Seite 7 Montag, 22. März 2010 11:00 11
GB
Read all safety warnings and all in-
structions. Failure to follow the warn-
ings and instructions may result in
electric shock, fire and/or serious in-
jury.
SAVE THESE INSTRUCTIONS.
Protect the battery charger from rain and
moisture. The penetration of water in a battery
charger increases the risk of electric shock.
Do not charge batteries of other manufactur-
ers. The battery charger is only suitable for the
charging of Würth batteries (NiCd/NiMH) with
a voltage range of 7.2 V to 24 V. Danger of
fire and explosion.
Keep the battery charger clean. Contamina-
tion may cause the danger of electric shock.

Tool Specifications

Battery Charger
Article number
Voltage range of chargeable
batteries (automatic voltage
detection)
Charging current:
Rapid charging (max.)
Trickle charging (approx.)
Allowable charging
temperature range
Charging time per battery capacity
(NiMH/NiCd) approx.
1.2 Ah
1.3 Ah
1.4 Ah
1.5 Ah
1.7 Ah
2.0 Ah
2.4 Ah
2.6 Ah
3.0 Ah
Weight according to
EPTA-Procedure 01/2003
Protection class

For Your Safety

AL 20-EMC
The numbering of the product features refers to the
0700 810
representation of the battery charger on the graph-
ics page.
Please open the fold-out page with the representa-
[ ] 7.2 – 24
V
tion of the device and leave it open while you are
reading the operating instructions.
[A] 5,0
[mA] 100
[°C] 0 – 45
[min] 15
[min] 16
* Not all of the accessories illustrated or described are
[min] 18
included as standard delivery.
[min] 19
[min] 22
[min] 27
[min] 30
Observe correct mains voltage: The voltage of the
[min] 33
power source must agree with the voltage specified
[min] 38
on the nameplate of the unit. Equipment marked
with 230 V can also be connected to 220 V.
[kg] 0.8
/ II
Check the battery charger, cable and plug
each time before using. Do not use the battery
charger when defects are detected. Do not
open the battery charger yourself and have it
repaired only by qualified personnel using
original spare parts. Damaged battery charg-
ers, cables and plugs increase the risk of elec-
tric shock.
Do not operate the battery charger on easily
inflammable surfaces (e. g. paper, textiles,
etc.) or combustible environments. There is
danger of fire due to the heating of the battery
charger during charging.
For further notes on safety refer to enclosed
sheet.

Product Features

1 Battery pack (without contact APT)*
2 Unlocking button*
3 Adapter (not included in the delivery)*
4 Green charging indicator
5 Red charge control LED
6 Charging compartment
7 Battery pack (with contact APT)*

Starting Operation

7