Candy CBO 150 NE Manual De Instrucciones página 14

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
• The guarantee is applicable only to new
products and is not transferable if the
product is resold.
• Our company disclaims any liability for
incidental or consequential damages.
• The guarantee does not in any way
diminish your statutory or legal rights.
• Do not perform repairs on this Wine
Coolers. All interventions must be
performed solely by qualified personnel.
SAFETY CHILDREN!
• If you are discarding an old product with a
lock or latch fitted to the door, ensure
that it is left in a safe condition to prevent
the entrapment of children.
• This appliance can be used by children
aged from 8 years and above and by
persons with reduced physical, sensory or
mental capabilities or with a lack of
experience and knowledge; provided that
they have been given adequate
supervision or instruction concerning how
to use the appliance in a safe way and
understand the hazards involved.
• Children should not play with the
appliance. Cleaning and user maintenance
should not be made by children without
supervision.
INSTALLATION
WARNINGS:
• Do not install the appliance in a damp or wet location as this could compromise
the insulation and result in leakage.
Furthermore, on the exterior of the same, condensate could accumulate
• Do not place the appliance in locations outside or near sources of heat or exposed
to direct sunlight.
The appliance operates properly within the range of environmental temperatures
indicated:
+10 +32'C for the climatic class SN
+16 +32'C for the climatic class N
+16 +38'C for the climatic class ST
+16 +43'C for the climatic class T
(See the nameplate of the product)
• Do not place containers with liquids on top of the appliance.
• Wait at least 3 hours after final placement before placing the appliance in
operation.
Electrical connection
After shipping, place the appliance vertically and wait at least 2-3 hours before
connecting it to the electrical system. Before inserting the plug into the electrical
socket, make sure that:
• The socket is earthed and in compliance with the law.
• The socket can withstand the maximum power load of the appliance, as indicated
on the nameplate of the refrigerator.
• The power supply voltage is within the amounts indicated on the nameplate of
the refrigerator.
• The cord must not be folded or compressed.
• The cord must be checked regularly and replaced solely by authorized technicians.
• The manufacturer declines any liability whenever these safety measures are not
respected.
Appliance start-up
Remove all wrapping/packaging present inside the appliance and clean with water
and baking soda or neutral soap.
After the installation, wait 2 - 3 hours to allow time for the refrigerator to stabilize
at normal working temperature, before placing fresh food inside.
If the power cord becomes disconnected, wait at least five minutes before
restarting the refrigerator/ freezer. At this point, the appliance is ready for use.
OPERATION
Turning On/Off (no display)
• The thermostat unit for control of the appliance is located inside of the
refrigerator compartment (Fig. 1).
Rotate the thermostat knob of the thermostat beyond the "0" position.
The light is on when the refrigerator door is open. Turning the knob to "0"
.
completely turns off the product
Temperature adjustment (no display)
• The temperature adjustment of both compartments is controlled by rotating the
thermostat knob (Fig. 2).
Select the desired position:
• For colder temperature in the refrigerator and in the freezer, by turning towards
5.
• For a less cold temperature in the refrigerator and in the freezer, rotate the
thermostat knob in the direction of 0.
CONSERVATION
• To maintain the best flavour, nourishment and freshness of foods, it is advisable
to store them in the refrigerator compartment as shown in Fig. 6
below, making sure to wrap them in aluminum or plastic sheets or in appropriate
covered containers to avoid cross-contamination.
Refrigerator zone
Fruit / Vegetables
• To decrease fruit and vegetable moisture losses they must be wrapped in plastic
materials such as, for example, films or bags and then inserted in the
fruit/vegetable zone. In this way rapid deterioration is avoided.
14

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ca51006

Tabla de contenido