Troubleshooting - Candy CBO 150 NE Manual De Instrucciones

COUPLING OF THE PANELS OF THE BUILT-IN COLUMN OF
THE APPLIANCE DOORS
The appliance is equipped with coupling devices for the appliance doors with the
column panels (loader slide).
PRECAUTIONS FOR THE CORRECT
OPERATION
Once the product has been embedded, place the rear part of the column in contact
with the wall so as to prevent access to the compressor compartment.
For the product to operate correctly it is essential to allow adequate air circulation
so as to cool down the condenser located in the rear part of the appliance.
For this reason, the column must be equipped with a rear chimney, whose upper
opening must not be blocked and with a front slot which will be covered with a
ventilation grill.
SUSPENDING USE OF THE APPLIANCE
If the appliance is not to be used for a long time:
1) Turn the appliance OFF (see Operation).
2) Extract the plug or remove the safety device.
3) Clean the appliance
4) Leave the doors of the appliance open.

TROUBLESHOOTING

PROBLEM CAUSE REMEDY
The inside Electricity absence. The power cord is
illumination light Door switch is not properly
bulb does not blocked. plugged in.
turn on. Check whether the
appliance is
switched off.
(see Temperature
Adjustment).
Ensure that there
is a current in the
house.
Check that it is
active.
The refrigerator The doors are not Check that the
and freezer do not closed. door and gaskets
sufficiently cool. The doors are close properly.
frequently opened Avoid unnecessary
Erroneous setting opening of the
of the doors for a
temperature. period of time.
The refrigerator Check the
and freezer have temperature
been setting and, if it is
excessively filled. possible, cool even
Surrounding more (see
temperature is too Temperature
low. adjustment)
No electrical Wait for the
power. stabilization of the
temperature of
the refrigerator or
freezer.
Check that the
ambient
temperature is in
17