Troubleshooting - Candy CCTOS 502WHN Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96

TROUBLESHOOTING

You may try to solve the following simple problems by yourself. If the problem cannot be solved, please
contact the after-sales department.
Failed operation
Problem
Odor
Long-time operation
of the compressor
Light fails to get lit
Doors don't close
properly
Loud noise
Door seal fails to be
tight
Water pan overflows
Hot housing
Surface condensation
Abnormal noise
Check that the appliance is connected to power or that the plug
Solution
is in well contact
Check that the voltage is not to low
Check that there is no power failure or that partial circuits have
not tripped
Odorous foods shall be wrapped tightly
Check whether there is any rotten food
Clean the inside of the refrigerator
Long-time operation of the refrigerator is normal when the
ambient temperature is high
It is not suggested having too much food in the appliance at the
same time
Food shall be cooled before being put into the appliance
The doors shall not be opened to frequently
Check whether the refrigerator is connected to power and
whether the illuminating light is damaged
Have the light replaced by a specialist
Check whether the door is stuck by food packages
Check whether the refrigerator is tilted
Check whether the refrigerator is placed stably
Check whether accessories are placed in the proper location
Remove foreign matters on the door seal
Heat the door seal and then cool it for restoration
Too much food is stored, or the stored food contains too much
water, resulting in heavy defrosting
The doors are not closed properly
Heat dissipating of the built-in condenser via housing is normal
If the compressor shuts down, provide ventilation to facilitate
heat dissipation
Condensation on the exterior surface and door seals of the
refrigerator is normal when the ambient humidity is too high.
Wipe the condensation with a towel
Buzz: the compressor may buzz during operation, particularly
upon start and stop. This is normal
Creak: refrigerant flowing inside the appliance may produce
creak. This is normal
20

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido