Troubleshooting Guide - Singer 4423 Manual De Instrucciones

Ocultar thumbs Ver también para 4423:
Tabla de contenido

Publicidad

Troubleshooting Guide

EN
Problem
Cause
Upper thread
1. The machine is not threaded correctly.
2. The thread tension is too tight.
breaks
3. The thread is too thick for the needle.
4. The needle is not inserted correctly.
5. The thread is wound around the spool holder pin.
6. The needle is damaged.
Lower thread
1. The bobbin case is not inserted correctly.
2. The bobbin case is threaded wrong.
breaks
1. The needle is not inserted correctly.
2. The needle is damaged.
Skipped stitches
3. The wrong size needle has been used.
4. The foot is not attached correctly.
1. The needle is damaged.
2. The needle is not correctly inserted.
Needle breaks
3. Wrong needle size for the fabric.
4. The wrong foot is attached.
1. The machine is not correctly threaded.
Loose stitches
2. The bobbin case is not correctly threaded.
3. Needle/ fabric/ thread combination is wrong.
4. Thread tension wrong.
1. The needle is too thick for the fabric.
2. The stitch length is adjusted wrong.
Seams gather or
3. The thread tension is too tight.
pucker
1. Poor quality thread.
2. The bobbin case is threaded wrong.
Uneven stitches,
3. Fabric has been pulled.
uneven feed
1. Lint or oil have collected on the hook or needle bar.
The machine is
2. The needle is damaged.
noisy
Thread is caught in the hook, because upper tension
The machine
is not threaded correctly.
jams
Correction
1. Rethread the machine.
2. Reduce the thread tension. (lower number)
3. Select a larger needle.
4. Remove and reinsert the needle. (flat side towards the back)
5. Remove the reel and wind thread onto reel.
6. Replace the needle.
1. Remove and reinsert the bobbin case and pull on the thread.
The thread should pull easily.
2. Check both bobbin and bobbin case.
1. Remove and reinsert needle. (flat side towards the back)
2. Insert a new needle.
3. Choose a needle to suit the thread and fabric.
4. Check and attach correctly.
1. Insert a new needle.
2. Insert the needle correctly. (flat side towards the back)
3. Choose a needle to suit the thread and fabric.
4. Select the correct foot.
1. Check the threading.
2. Thread the bobbin case as illustrated.
3. The needle size must suit the fabric and thread.
4. Correct the thread tension.
1. Select a finer needle.
2. Readjust the stitch length.
3. Loosen the thread tension.
1. Select a better quality thread.
2. Remove bobbin case, thread and insert correctly.
3. Do not pull on the fabric while sewing, let the feed dogs pull
the fabric under the foot.
1. Clean the hook and feed dog as described.
2. Replace the needle.
Remove the upper thread and bobbin case. Gently rock the
handwheel backards and forwards by hand and remove the thread
from the bobbin area.
55

Publicidad

Tabla de contenido
loading

Tabla de contenido