Publicidad
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Caregiver
Read the "User Guide" carefully before use
•
and keep it for future reference. Incorrect
use of this product may cause serious injury
to the user
Always use the correct lifting techniques
•
and aids for this purpose
Never leave the user unattended in this
•
product. Ensure permanent supervision by
an adult
Repair/replacements must only be made
•
using new original R82 spare parts and fit-
tings and carried out in accordance with the
guidelines and service intervals prescribed
by the supplier
If there is any doubt as to the continued
•
safe use of your R82 product or if any parts
should fail, stop using the product immedi-
ately and contact your local dealer as soon
as possible
Environment
Observe the surface temperature on the
•
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the sur-
face temperature is above 41°C then allow
the product to cool before use
Use this product on a level surface without
•
any obstacles. Be aware of reduced maneu-
verability on slippery surfaces
When using on inclines, please refer to
•
measurements
•
Do not use the product where there is
a risk that other electrical systems can
interfere with the electrical system on the
product
User
If the user is close to the max. load limit
•
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
considered
support.R82.org
ENGLISH
Product
Carry out all positional adjustments on the
•
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
Activate the brakes before placing the user
•
into the product
Ensure the stability of the product is main-
•
tained before placing the user in it
We recommend you notify the user before
•
angling the seat and back
Before moving the chair, with or without
•
an user seated, please ensure the seat is
in horizontal position, the back in vertical
position and the seat height above floor is
as low as possible. Do not move an angled
seat
Ensure the castors are fully-functional and
•
secure before use
Inspect the product and all of its accesso-
•
ries and replace any worn out parts before
use
Do not expose the gas spring to pressure or
•
high temperatures. DO NOT puncture
Do not expose the piston rod to scratches
•
etc. It is important to use a cloth or the like,
if tools are used to adjust the gas spring
The emergency stop is activated when using
•
the red button on the control box
This product is tested for resistance to igni-
•
tion at level non-ignition in accordance with
EN 1021-1 and EN 1021-2
This product might loose its flame resistant
•
characteristics if using other than original
upholstery
33
EN
Publicidad
