Care And Maintenance - Kärcher VC 4i Cordless Manual Del Usuario

 Attach the dusting brush.
For cleaning wall surfaces, curtains,
gaps in furniture, etc.
You can use the flexible hose to extend
the length.
Illustration H
 Attach the crevice nozzle.
Illustration F
For cleaning joints, grooves between
1
doors and windows, tiny slits, etc.
For cleaning delicate objects with care,
2
e.g. bookcases, handicrafts, etc.
 Attach the upholster brush.
For cleaning upholstered furniture, mat-
tresses, laced curtains, etc.
 Attach the mattress nozzle.
For cleaning mites / dust in the mattress-
es and pillows, etc.
Operation
1. Place the vacuum cleaner on the sur-
face to be cleaned.
2. Press the ON/OFF button to start vacu-
uming up the dust / dirt.
The appliance runs at high speed.
Illustration I
3. Press the energy saving mode button.
The appliance runs at low speed.
Illustration J
4. Press the floor nozzle button to switch
the floor nozzle on or off.
Illustration K
Adjust the suction power
You can adjust the suction power while vac-
uuming via the energy saving mode button.
Illustration J
 Energy saving mode off: The appliance
runs at high speed, and the full mode in-
dicator is on.
 Energy saving mode on: The appliance
runs at low speed, and the full mode in-
dicator is off.
Storage
Note
 Store the appliance in a dry room.
 Consider the weight of the appliance
when storing it.
 The storage holder is not removable.
20
1. Insert the storage holder into the storage
base.
Illustration L
Storage holder
1
Storage base
2
2. Insert the appliance into the storage
dock.
Illustration M
3. Put the charger, the crevice nozzle and
the upholster brush into accessory stor-
age.

Care and maintenance

Note
 Use the appliance only when all filters
and the dust container are installed.
 Defective filters and filters that can no
longer be cleaned must be replaced.
Before doing any work on the appliance:
1. Switch off the appliance.
2. Unplug the power supply from the power
outlet.
Cleaning the HEPA 12 filter /
cyclone cover and emptying the
dust container
Note
 If the HEPA 12 filter cannot be cleaned,
it must be replaced.
 Do not dry the HEPA 12 filter and the cy-
clone cover using a hair dryer.
1. Unlock the dust container, and pull out
the dust container.
Illustration N
2. Unplug the HEPA 12 filter and the cy-
clone cover from the dust container.
Illustration O
3. Turn the cyclone cover clockwise, and
separate the HEPA 12 filter from the cy-
clone cover.
Illustration P
4. Clean the HEPA 12 filter and cyclone
cover under running water.
Illustration Q
5. Allow the HEPA 12 filter and cyclone
cover to dry completely.
6. Empty the dust container, and rub down
inside it using a cloth.
Illustration R
English