Baby Jogger city mini GT2 double Instrucciones Del Ensamblaje página 12

FRAME
EN
1 Unpack the stroller frame from the box
and set the wheels aside.
Unlock the stroller by pulling the auto-
lock lever.
2 Unfold the stroller by pulling the
handlebar away from the frame. The
stroller will lock into place and you will
hear a click.
3 Place the stroller in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay stroller on its back so the
handlebar is resting on the floor.
• Attach front wheels by sliding them
into the front wheel mount until it
clicks. Gently pull on the front wheel
to make sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount.
SWIVEL FEATURE
6 Push the swivel button down and
rotate to the left to lock the front wheel
assembly in a fixed position for long
distance strolling.
7 Push the swivel button down and
rotate to the right to allow the front
wheel assembly to swivel.
WARNING: When loading and
unloading child, lock the front wheel
in a fixed position. Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame and
insert it into the wheel mount until it
locks into place. You will hear a click.
• Gently pull on the rear wheel to make
sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
HANDLE
10 Press the handle release buttons on
both sides and rotate up or down to
the new position.
BRAKE
11 To Lock the Brakes: gently pull the
Brake Lever into upright position until it
clicks into place.
12 To Release the Brakes: Pinch the gray
tabs and pull the lever towards you.
Push the Brake Lever down until it is
parallel with the frame.
WARNING:Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
CANOPY
13 Attach the canopy to the frame by
sliding the canopy onto the mounting
brackets. To remove, slide canopy off
of mounting brackets.
NOTE: When using a Car Seat, canopy
must be removed.
14 Snap the 3 snaps to the stroller frame.
15 Attach the fastening strip on the back
of the canopy to the frame.
16 Pull forward to open canopy and push
backwards to close canopy.
17 There are two canopy windows, a top
one and back one. To use them, roll
the shade up towards the top and
secure with the elastic and button.
ADJUSTING SAFETY HARNESS
18 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
19 Reinsert stopper at seat opening
closest to child' s shoulders. Pass back
through seat fabric and PE board. Tug
on strap to ensure stopper is locked.
Repeat on both sides.
12