Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating the pool cleaner - Quick start guide
1. Place Ihe power supply (Iransformer) al
leasl
3.6 meiers
/11.8
feel from Ihe pool and al
leasl 12
cm /4
Inch above
Ihe surtace (ftg.1).
The transformerwill
supply
low
voltage
10
thecleaner.
2. Unccil
the cable.(ftg.1a)
3. Place the unil
in
Ihe waler.
Tum Ihe
unil
side 10 side
in
the waler 10 allow air 10
escape from
the body
and
then
let the cleaner
sink 10 Ihe bottom of
the
pool
(fig.3).
Then,
spread
Ihe
cable over Ihe
surtace of the
pool as
evenly as possible
(ftg.1).
unit
.
m
.8ft
12
cm
(4.7 inch)
,.
4. Plug Ihe cable inlo the power supply. Depending on
your
model (Type I or Type
11),
make sure Ihe
key
on the ptug corresponds exaclly
with
the
key
slol on the sockelof
the power supply (fig.3a).
(See
details
on
the nex! page)
11
5. Plug the power
supply
inlo a grounded outlet. Ensure thai the electric outlel has been
properlygrounded (fig.3b).
6. The lighlwill glow indicating Ihal the syslem is· ON
·
and
the pool cleaner
will
startthe
cieaning cycie. The unil
keeps
record of Ihe number of cleaning
cycles.
Only an
authorized service cenlercan display
the
accumulaled
cleaning
cycles.
3a
-
Type 11
4
IMPORTANT:
Please
be
sure 10 always keep your pool cieaner properly slored anywhere
between 10 10 40 degrees Celsius (50 10 104 degmes
Fahrenheil).
This will
keep the
molors,
ptastics and seals
prolected.
Failum 10 comply will resull in
lossofwarranty.
Robolcan
be
used in walerwith lemperatures ranging !rom 13"C 10 35"C (55"F
10
95"F). However,
the mcommended optimal lemperature is between 22"C
and
32"C (72"F and 90"F)
Publicidad
Tabla de contenido
