Astralpool R3 Guia De Inicio Rapido página 13

Operating the pool cleaner - Plugging the cable
Plugs Type I
Ta plug the cable (Fig A) inlo Ihe socket on Ihe power supply (Fig. B). please do the
following:
1.Prepare the plug as seen in (Fig. C) with the key and 3 outside slols exacUy as shown.
2.Fit exacHy the key and the slots from cable plug with the corresponding key and slots
trom the powersupply socket. (Fig. D)
3.Push the plug into the socket ofthe power supply all the way in.
4.0nce the plug is in, rotate the plug to the nght to lock it into place (Fig. E).
5.To remove the plug, first rotate the plug to the left to unlock it, then pull it out (Fig. F).
®
cable
plug
®
power supply
socket
--.-.)
Push and rotale
rijJhllo lock
©
sot
cable
plug
@
slot
key
power supply
socket
Cable plug (A)
12
Plugs Type 11
Ta plug the cable (Fig A) into the socket on the power supply (Fig. B). please do the
following:
1.Prepare the plug as seen in (Fig. C) with the key and the nserexacUy as shown.
2.The nsershould face up (Fig. E) in orderto keep the socket cap open. The cap will lock
thecable in place.
3.Fit exacUy the key with the corresponding key slot trom the power supply socket.
Although the socket has 4 holes, only the top and the bottom one will be used (Fig. D)
4. Push the plug into the socket ofthe powersupply all the way in.
®
cable
plug
Cable plug (A)