Fuel And Oil Mixture
Your snow thrower is equipped with a two-cycle engine that
requires a mixture of gasoline and two cycle oil at a ratio of 50:1.
Refer to the engine operator's manual for detailed instructions
regarding the mixture of oil and gasoline for your snow thrower's
engine.
Fuel Fill-Up
WARNING!
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
1.
Check fuel level and add if necessary. Follow related
instructions in the separate engine manual packed with
your snow thrower .
NOTE: A plastic insert may have been placed into the fuel tank to
prevent dirt and debris from entering the tank during assembly.
Remove this insert before attempting to fill with fuel.
Adjustments
Chute Assembly
The pitch of the chute assembly controls the angle at which the
snow is thrown.
1.
Loosen the wing knob found on the left side of the chute
assembly and pivot the upper chute upward or downward
to the desired pitch. Retighten the wing knob before
operating the snow thrower.
2.
Position the chute assembly opening by using the Chute
Handle to throw the snow in the desired direction. See Fig.
3-4.
Figure 3-4
s
3 — a
& s
-u
ectiOn
sseMbly
et
p