Specifications; Troubleshooting - Tanita WB-3000 Manual De Instrucciones

Weight Measurement
Height Measurement
Input Items
Output Items
Size
Output Data Interface
Power Consumption
Temperature Range of usage
Weight of Equipment
If you are concerned that the scale may not be functioning correctly, please check the following point before requesting repairs.
Problem
Nothing is displayed when
pressed.
"Lo" is displayed.
Measurement is not accurate.
The weight does not stabilize
"OL" is displayed
"-OL" is displayed
"Error" is displayed

12. Specifications

Model
Measurement System
Maximum Capacity / Minimum Graduation
Standard
Range of Weight
Step on
Measurement System
Range of Height
Height
Weight
Display Height
Overall
Platform
Display
Power Source
Rated Power
Battery Life

13. Troubleshooting

• Check the connection of the AC adapter jack to the DC jack, and the connection of the AC adapter
key is
plug to the wall outlet.
• The batteries may be weak. Try an AC adapter or new LR6 (AA) batteries.
• Check the terminals of the batteries for contamination
The batteries are running out. Please replace them immediately or use the AC adapter.
• Check that all feet of scale are stable and on a hard flat surface, carpeting depth should be kept to a
minimum.
• After having stepped down from the scale and pressed the ON key, perform the measurement again.
• Accurate measurement may be impossible if the product is used where there is excessive vibration.
• Try using the product in a different place.
• Are you moving during measurement?
• Is the measured weight within the range of weight measurement?
• Are you touching the height rod arm, switch, or another part during measurement?
• The range of weight (660lb/300kg) is exceeded.
• Was anything placed on the scale before measurement?
• Check whether the cable between the platform and display is disconnected, cut, or pinched.
660lb / 0.2lb
0 - 660lb
22 - 660lb
2ft 1in – 7ft
2ft – 8ft 2in 0.5in increment
660lb / 0.2lb
2ft – 8ft 2in 0.5in increment
BMI
20.8 x 15.0 x 54.4 in
15.0 x 15.0 x 2.0 in
Upper 5Digits and Lower 4Digits LCD
RS-232C (D sub 9-pin Male connector) USB (B-type)
AC adapter (included) Center Minus
32°F - 95°F
25.3lb (without batteries)
DC 6V 200mA (LR6 - AA Alkaline Battery x 4 included)
Approximately 100hours of continuous use when using LR6 (AA
Check Points
WB-3000
Strain Gauge Load Cell
300kg / 0.1kg
0 - 300kg
10 - 300kg
Mechanical Height Rod
64cm – 214cm
61cm- 250cm 1cm increments
300kg / 0.1kg
61cm- 250cm 1cm increments
0.1 increments
528 x 380 x 1381 mm
380 x 380 x 51 mm
Height of numerals 1in / 24mm
0.3 W max.
0°C - 35°C
11.5kg (without batteries)
Alkaline battery)
11