Output Data Format - Tanita WB-3000 Manual De Instrucciones

This section covers the exporting of data from the scale to an external device (e.g. PC) using a RS-232C and USB compliant signal.
• RS-232C and USB interface are for data OUTPUT ONLY!
• This scale is not capable of receiving instructions from an external device.
Specifications
Communications standard
Communications method
Signal speed
Data bit length
Terminator
• An RS-232C connector (D sub 9-pin female) and USB connector (B-type 4-pin female) are located on the back of the display unit.
ote:
• Please provide your own cables as necessary as none are included.
RS-232C :Straight D sub 9-pin (male) – D sub 9-pin (female)
USB :A-type 4-pin (male) – B-type 4-pin (male)
• Select Switch : Please select which interface you would like to use
Signal Line Name and Connection Method
Terminal no.
1
2
3
4
5
6
7
8
9

11. Output data format

Parity
Stop bit
RS-232C Port
If you want to use the USB output, you must install the necessary driver onto your PC, available to download from
http://www tanita com.
Signal name
EIA RS-232C compatible
RS-232C/USB Select SW
TXD
RXD
GND
USB
Asynchronous transaction
9600 baud
8 bits
None
1 bit
CR+LF
USB Port
1 5
6 9
9