Display Name And Beeper Settings; Changing The Autoloader Display Name; Enabling The Beeper - Rimage Professional 2450 Guia Del Usuario

Display Name and Beeper Settings

The Rimage software includes an application called Gemini Utilities,
which is used to change the display name of the system and to
enable the beeper. Gemini Utilities is part of Rimage Software Suite
and must be run from the computer connected directly to the
system.
Tip: Unless otherwise indicated, all Windows navigation statements
are Windows 10 paths. Other Windows versions may differ.

10.1: Changing the Autoloader Display Name

Use Gemini Utilities to enter the name displayed on the operator panel.
Important: Changing the display name does not change the name of
the system on a network or workgroup. To change the name on a
network or workgroup, refer to your setup and installation
instructions or the Rimage Advance Setup (Networking) Guide.
1. From the Windows Start menu select All Programs > Rimage >
Utilities > Gemini Utilities.
2. Select the Override Name checkbox.
3. Clear the Use Computer Name checkbox.
4. In the Display Name field, enter the new name.
5. Select Set Params to set the name.
6. Restart the computer for changes to take effect.
2004849_A

10.2: Enabling the Beeper

You can change the number of beeps that occur when the unit is out of
media or when there is an error.
1. From the Windows Start menu select All Programs > Rimage >
2. In the # of Beeps on Fault field, select the number of beeps you
3. Select Set Params to set the number of beeps
4. Restart the computer for changes to take effect.
Tip: To disable the beeper, set the number to zero.
For more information visit rimage.com/support
Utilities > Gemini Utilities.
wish to hear when there's an error.
10