Important Safety Instructions; Special Instructions - Rowenta DA1510 Manual Del Usuario

1103903520 - DA1510:Mise en page 1 24/09/08 14:45 Page 2

IMPORTANT SAFETY INSTRUCTIONS

When using your flatiron, basic safety precautions should always be followed, including the fol-
lowing:
READ ALL INSTRUCTIONS BEFORE USING
1.Use iron only for its intended use.
2.To protect against a risk of electric shock, do not immerse the iron in water or other liquids.
3.The iron should always be turned to "Off" before plugging or unplugging from outlet. Never
yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
4.Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop
cord loosely around iron when storing.
5.Always disconnect iron from electrical outlet when filling with water or emptying and when
not in use.
6.Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To
avoid the risk of electric shock, do not disassemble the iron, take it to a qualified serviceman
for examination and repair. Incorrect reassembly can cause a risk of electric shock when the
iron is used.
7.Close supervision is necessary for any appliance being used by or near children. Do not
leave iron unattended while connected or on an ironing board.
8.Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you
turn a steam iron upside down – there may be hot water in the reservoir.
9.If the malfunction indicator goes on, the flatiron is not operating normally. Disconnect form
the power supply and have the flatiron serviced by qualified service personnel.
10. For use in the U.S.A., the voltage selector switch should be placed in the 120-volt position.
For use in several countries overseas, the voltage selector switch may need to be placed in
the 240-volt position. Confirm the voltage available at each overseas location before using the
flatiron. For connection to a 240-volt supply, use a suitable attachment plug adapter of the
proper configuration for the power supply receptacle.
11. Be sure dual voltage selector is in correct voltage position before operating. Before plug-
ging in, read the information about dual voltage operation contained in the instruction section
of this manual.
12. This appliance was set at the factory to operate at 120 volt. Refer to Operating Instructions
section of this manual for conversion to 240 volt operation

SPECIAL INSTRUCTIONS

1.To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
2.If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated
for less amperage may overheat. Care should be taken to arrange the cord so that it cannot
be pulled or tripped over.
SAVE THESE INSTRUCTIONS