Cosatto Nitty Gritty PORT Manual De Usuario página 7

Fitting & Operation Information
Child car seat (with vehicle belt)
1
Location
IMPORTANT: Never use the child restraint system on a seat where an
airbag is fitted and active. Refer to your vehicle user manual for
information on de-activating the airbag.
WARNING: Your child restraint system can only be installed rearward
facing using a three point lap and diagonal vehicle belt in the front or
rear passenger seats of the car.
2
Fitting
6 7 (1).
Put the handle in carrying position
Position the child car seat on the vehicle seat, pass the vehicle waist belt through the
side vehicle belt guides (2) and fasten the vehicle buckle (3).
Route the diagonal belt under handle hinge (4) then through rear vehicle seat belt
guide (5).
Tension the diagonal belt (6).
IMPORTANT: The position of the vehicle belt buckle can affect the
stability of the child restraint system. In an accident this could stop
the child restraint system from protecting your child as well as it
should. After tightening the vehicle belt, if the buckle lies in the
position marked then try fitting the child restraint system in
another seating position in your vehicle.
If in doubt, consult either the child restraint system manufacturer or
retailer.
Harness
3
Loosening:
NOTE: Pull straps not chest pads.
4
Tightening
NOTE: The harness must be reasonably tight. It should restrain but not make the
child uncomfortable. Check that the straps are not twisted while the child is seated.