Roger Technology EDGE1 Instrucciones Y Advertencias Para El Instalador página 78

14
DISPLAY POSSIBLE CAUSE
STOP
Sensing edge COS1 not connect- Set the parameter
Sensing edge COS2 not connected Set the parameter
Photocell FT1 not connected or in- Set the parameter
Photocell FT2 not connected or in- Set the parameter
78
ACTION BY SOFTWARE
-
-
-
-
-
-
-
ACTION
STOP
is set
jumper the ST
COM
if not Jumper contact COS1
tact COM, if not used or to disable
if not Jumper contact COS2
COM
e Jumper contact FT1
COM
e Jumper contact FT2
COM
PP - COM contacts and con-
- COM contacts and con-
AP - COM contacts and con-
PED - COM contacts and
ORO - COM
tact must not be jumpered if not
-
-
-
-