Publicidad
Function
• Possible operating systems:
Märklin Digital, Märklin Systems.
• Addresses that can be set (Control Unit): 01 – 80.
Address set at the factory: 77.
• One function can be selected with the 0 setting on a
digital controller's speed control knob. Only one of the
three functions can be actively controlled at any one
time.
• The function is automatically ended by setting the
control knob back to 0.
• The movements of the functions are automatically
ended after 10 seconds, as long as no other speed level
data is carried out at the controller.
The movement is carried out again, when the control
knob is set to 0 and is then turned up high again.
• The setting for the control knob determines the speed
at which the function is carried out.
• In the event the current to the crane car is interrupted,
the function is turned off. It is reactivated, when the
control knob is set to 0 and then turned up high again.
• The ability of the hook on the line to raise loads de-
pends on the position of the boom:
High position for the boom = high level of lifting power
Low position for the boom = low level of lifting power
Do not try to activate the functions manually!
The maintenance work necessary with normal operation
of this locomotive is described below.Please see your
authorized Märklin dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those cases
where parts neither manufactured nor approved by Märklin have
been installed in Märklin products or where Märklin products have
been converted in such a way that the non-Märklin parts or the
conversion were causal to the defects and / or damage arising. The
burden of presenting evidence and the burden of proof thereof,
that the installation of non-Märklin parts or the conversion in or of
Märklin products was not causal to the defects and / or damage
arising, is borne by the person and / or company responsible for
the installation and / or conversion, or by the customer.
Safety Warnings
• This locomotive is to be used only with an operating
system designed for it (Märklin Digital or Märklin Systems).
Use only transformers rated for your local hosehold
!
power.
Do not under any circumstances use transformers
rated for 220 volts or 110 volts
• This locomotive must never be supplied with power
from more than one transformer.
• Pay close attention to the safety warnings in the
instructions for your operating system.
WARNING! This product contains magnets. Swallowing
more than one magnet may cause death in certain
circumstances. If necessary, see a doctor immediately.
5
Publicidad
