Troubleshooting - HoMedics AP-T10-EU Manual De Instrucciones

To purchase genuine HoMedics replacement/spare parts please visit www.homedics.co.uk
3 Pack of aroma pads - ARM-PAD3
Aroma tray - AP-T10WTARM
HEPA filter - AP-T10FLR
Essential Oils:
ARM-EO15LAV
ARM-EO15EUC
ARM-EO15ORG
ARM-EOGPF
ARM-EO15LEM
ARM-EOLMG
ARM-EO15WD
ARM-EO15OU
ARM-EO15GG
ARM-EO15BC
ARM-EO15PIN
ARM-EO15WNL
ARM-EO15RSM

TROUBLESHOOTING

PROBLEM
Unit will not operate
Reduced airflow
Reduced odour removal
Excessive noise
Replace filter light remains lit
after filter replacement
Display lights are off
POSSIBLE CAUSE
• Unit is not plugged in
• Power button not pressed
• No power to unit
• HEPA-type filter is not installed correctly
• Grille cover is not installed correctly
• The back grille may be blocked
• Pre-filter needs vacuuming
• The HEPA-type filter needs to be replaced
• The HEPA-type filter needs to be replaced
• The unit is not level
• The replace filter indicator needs to be
reset
• Nightlight setting
I
GB 5
SOLUTION
• Plug unit in
• Press the power button to turn the power on
• Check fuses, try a different outlet
• Reinstall the HEPA-type filter
• Reinstall the grille cover
• Check to make sure nothing is blocking the back
grille and air outlet
• Vacuum the pre-filter with the brush
attachment of your vacuum cleaner
• Replace the HEPA-type filter
• Replace the HEPA-type filter
• Place the unit on a flat, level surface
• Press and hold the ioniser button for 3 seconds
until the replace filter light turns off
• Press the nightlight button until the desired
lights are on/off