Descargar Imprimir esta página

Publicidad

Enlaces rápidos

DIR 1000650R0503 Version 00 - 140G-R
LSIG-MM microprocessor-based electronic release for 140G-R
Sganciatore elettronico a microprocessore LSIG-MM
Elektronischer Mikroprozessor-Auslöser LSIG-MM
Déclencheur électronique à microprocesseur LSIG-MM
Relé electrónico con microprocesador LSIG-MM
Installation - Installazione - Instalación
Instalação -
To prevent electrical shock, disconnect from power source before
WARNING:
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
WARNUNG:
Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden.
AVERTISSEMENT:
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs.
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes.
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes.
警告:感電事故防⽌のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。
警告:为了防止触电,在安装或维修之前必须先切断电源。安装在合适的设备
箱内。防止接触污染 。)
LSIG-MM
2
See DIR 1000529R0510
Screw
LENGTH
20 mm (0.79" )
DIR 1000650R0503 Version 00
-
Screw
LENGTH
dia.
1 0 mm (0.39" )
4
Connection
cables
Retaining
plug tool
Screw
x4
dia.
LENGTH
3
6 mm (0.24" )
140G-R
Locking
cover
Plate
Required tool
xx lb-in
xx Nm
dia.
3
Bul. 140G
2
1
Label

Publicidad

loading

Resumen de contenidos para Allen-Bradley LSIG-MM

  • Página 1 Bul. 140G DIR 1000650R0503 Version 00 - 140G-R LSIG-MM microprocessor-based electronic release for 140G-R Sganciatore elettronico a microprocessore LSIG-MM Elektronischer Mikroprozessor-Auslöser LSIG-MM Déclencheur électronique à microprocesseur LSIG-MM Relé electrónico con microprocesador LSIG-MM Installation - Installazione - Instalación Instalação - To prevent electrical shock, disconnect from power source before WARNING: installing or servicing.
  • Página 2 LENGTH dia. 6 mm (0.24" ) LENGTH dia. 1 0 mm (0.39" ) DIR 1000650R0503 Version 00...
  • Página 3 LENGTH dia. 6 mm (0.24" ) DIR 1000650R0503 Version 00...
  • Página 4 DIR 1000650R0503 Version 00...
  • Página 5 ≤ 9.7 lb in LENGTH dia. 20 mm (0.79" ) 1.1 Nm DIR 1000650R0503 Version 00...
  • Página 6 At the end of its life, this equipment should be collected separately from any unsorted municipal waste Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies.