Uline H-7741 Manual Del Usuario página 2

2. Insert adjustable glide into foot of each leg.
(See Figure 2)
Figure 2
Adjustable Glide
• For Desk and Table assembly, proceed to
Step 3.
• For L-Desk and L-Desk Workstation assembly,
proceed to Step 1 on page 4.
• For Back-to-Back Workstation assembly,
proceed to Step 1 on page 6.
3. (Optional) If privacy panel was purchased, align
dual bracket with holes on top of support frame
and attach using two M6 x 15 mm bolts. Repeat
for remaining holes on same side of support frame.
Insert acrylic panel into dual brackets with holder.
(See Figure 3)
Figure 3
Acrylic
Panel
NOTE: If privacy panel is attached, keep frame
upright for Steps 4-5. (Optional privacy panel is
not shown.)
PAGE 2 OF 24
DESK AND TABLE ASSEMBLY CONTINUED
Dual Bracket
with Holder
M6 x 15 mm
Bolt
4. Place top on ground with underside facing up and
flip over assembled frame. Align holes on top with
holes on frame and attach using 10 M6 x 60 mm
bolts. (See Figure 4)
NOTE: For H-8948 and H-8999, attach top and
frame using eight M6 x 60 mm bolts.
Figure 4
Allen Wrench
M6 x 60 mm Bolt
5. If assembling a desk, align holes on modesty panel
with holes on legs and attach using four M6 x 12 mm
bolts. (See Figure 5) If assembling a table, apply
adhesive covers to holes on legs. (See Figure 6)
NOTE: Ensure desktop is attached before
attaching modesty panel.
Figure 5
Allen
Wrench
M6 x 12 mm
Bolt
0421 IH-7741