Uline H-7741 Manual Del Usuario página 7

BACK-TO-BACK WORKSTATION ASSEMBLY CONTINUED
4. Workstation is now fully assembled.
Completed
Assembly
Acrylic Panel x 1
1. Place desk frames together. Align dual bracket
with holder with holes on top of support frame and
attach using four M6 x 15 mm bolts. Repeat for
remaining dual brackets with holder. Insert acrylic
panel into dual brackets with holder. Align dual
bracket with holes on top of leg frames and attach
using four M6 x 15 mm bolts. Repeat for remaining
dual brackets. (See Figure 16)
Figure 16
Dual Bracket
with Holder
PAGE 7 OF 24
2-person Set
L-DESK WORKSTATION PARTS LIST
Dual Bracket with Holder x 2
L-DESK WORKSTATION ASSEMBLY
M6 x 15 mm
Bolt
Dual Bracket
Completed
Assembly
Dual Bracket x 2
NOTE: Additional L-Desk sets can be added
to create longer configurations. To extend
workstation, attach dual brackets to end of
desks and connect additional sets during
this step.
2. Place tops over frames. Align holes on tops with
holes on frames and attach using M6 x 60 mm bolts.
(See Figure 17)
NOTE: Parts from page 1 will be used during
this step.
Figure 17
4-person Set
M6 x 15 mm Bolt x 16
0421 IH-7741