Water Tank Sc-500Pd; Start Up The Sc-500Pd - SCANMASKIN SCAN COMBIFLEX 500I Manual De Instrucciones

4.4

Water tank SC-500PD

To increase the flow of the water turn the knob counter clockwise. The knob will move outwards.
To decrease the flow of the water, turn the knob clockwise. The knob will move inwards.
To quickly stop the water flow, push the button on the knob. This releases the knob and a spring
will pull it inwards.
Secure the knob by tighten it slightly to ensure that no water will flow.
To empty the water tank before lying down transport, increase the water flow to a maximum and
let the water pour out. Make sure the tank is empty before lying down transport.
Empty the tank before long time storage.
4.5

Start up the SC-500PD

See "4.1 Precautions" before starting the machine.
How to start the machine
 Make sure that the power plug and hoses for dust collector and water (if water supply is
used) are connected to the machine.
 Turn on the dust collector if used.
 Push the handle downwards to lift the gear barrel about 10 cm (4") from the ground.
 Make sure that the "EMERGENCY STOP" is in its upper position.
 Press the "START" button on the control panel.
 Lower the gear barrel down to the floor.
60
www.scanmaskin.com