Bytes
8 a 13
Nota: el dispositivo Shure debe responder en menos de un segundo en una red típica. Si no hay respuesta, intente enviar la consulta de nuevo des
pués de verificar la dirección IP de destino y el número de puerto.
*UDP: Protocolo de datagramas del usuario
The packet bridge does not allow cross-subnet command strings.
QoS (Quality of Service) Settings
QoS settings assign priorities to specific data packets on the network, ensuring reliable audio delivery on larger networks with
heavy traffic. This feature is available on most managed network switches. Although not required, assigning QoS settings is re
commended.
Note: Coordinate changes with the network administrator to avoid disrupting service.
To assign QoS values, open the switch interface and use the following table to assign Dante -associated queue values.
•
Assign the highest possible value (shown as 4 in this example) for time-critical PTP events
•
Use descending priority values for each remaining packet.
Dante QoS Priority Values
Priority
Usage
Time-critical PTP
High (4)
events
Medium (3)
Audio, PTP
Low (2)
(reserved)
None (1)
Other traffic
Note: Switch management may vary by manufacturer and switch type. Consult the manufacturer's product guide for specific configuration details.
For more information on Dante requirements and networking, visit www.audinate.com.
Networking Terminology
PTP (Precision Time Protocol): Used to synchronize clocks on the network
DSCP (Differentiated Services Code Point): Standardized identification method for data used in layer 3 QoS prioritization
Puertos y protocolos IP
Control Shure
Puerto
TCP/UDP
Protocolo
21
tcp
FTP
22
tcp
SSH
Contenido
Dirección MAC, como matriz de 6 bytes
DSCP Label
Hex
CS7
0x38
EF
0x2E
CS1
0x08
BestEffort
0x00
Descripción
Requerido para actualizaciones del firmware (en caso contrario
cerrado)
Asegurar la interfaz de cubierta
®
Decimal
Binary
56
111000
46
101110
8
001000
0
000000
Configura
ción de fábri
ca
Cerrado
Cerrado
Shure Incorporated
40/50