Publicidad
Installation
Determine where you want to mount the gate. For optimum
safety, the mounting location must be a solid wood or metal
surface.
Step 1
On both sides of the opening, make a mark for mounting the
bottom screw eyes 6" up from the top of the ooring or carpet.
(Fig. 1)
Step 2
Measure up exactly 16" from the bottom marks and make a
mark for the top screw eyes. (Fig. 1)
Step 3
Drill 4 (four) pilot holes, approximately 3/4" deep, for the screw
eyes using a drill with a 1/8" bit. Screw one of the screw eyes
into each hole until no thread is visible.
Step 4
Position the gate in opening with plastic safety rail up. Attach
the gate by inserting the hook into lower screw eye (Fig. 2) and
secure the locking latch to the top screw eye (Fig. 3).
Step 5
Lift the other end of gate and insert the hook into the other
lower screw eye (Fig. 2) and secure the other locking latch to
the top screw eye (Fig. 3).
Operating the Gate
To open gate, unlock one of the locking latches, raise gate to clear
the hook and swing out of the way. The gate may be quickly and
easily removed from the opening by unlocking both latches.
Figure 1
16
"
6
"
Figure 2
Figure 3
Page 3
Publicidad
