HEIDENHAIN MSE 1350 Instrucciones De Instalación página 21

Installing right end cover
Left and right end cover kits are provided with each power supply module for covering
open module ends. The left end cover is mounted on the first power supply module in the
chain.
To install the right end cover:
Insert the right end cover into the right side of the last module in the chain
X X
Insert end cover screws through the end cover mounting holes and into the end cover
X X
screw holes 12 on the module
Using a cross-head screwdriver, tighten the screws
X X
Installing cable mounting hardware
A cable mounting hardware kit is provided with each module for routing cables. Each kit
contains two sets of mounting hardware.
Insert the M3 hex nut into the cable mounting slot 14 on the bottom of the module
X X
Insert the M3 screw through the cable tie holder and fasten to the M3 hex nut using a
X X
cross-head screwdriver
Insert the cable tie through the cable tie holder and fasten cables
X X
Releasing a module
Verify power is removed from all power supply modules in the module chain
X X
Press a flat-edge screwdriver into the lock tab receiver 6 opening at the top
X X
left of the right hand module and press down on the lock tab 3 of the left hand
module to release the module
Gently apply upward pressure, depressing the DIN rail spring 9
X X
While maintaining upward pressure, rotate the top of the module away from the DIN
X X
rail
Gently release the upward pressure, releasing the module from the DIN rail
X X
Installing right end cover
Releasing a module
21