Dymo LabelWriter Twin Turbo Guia De Inicio Rapido página 6

3. Connecting your LabelWriter Printer
Do not connect the printer to your computer until
instructed to do so during the software installation.
To connect the cables
Plug the power cord into the power adapter.
1
See Figure 4.
Plug the power adapter into the power
2
connector on the bottom of the printer. See
Figure 5.
Plug the other end of the power cord into a
3
power outlet.
Plug the USB cable into the USB port on the
4
bottom of the printer. See Figure 5.
Insert the power and USB cables through the
5
cable channel and set the printer down.
DO NOT CONNECT the other end of the USB cable to
NOTE
your computer until asked to do so during the software
installation.
When prompted by the software installer, plug the USB
6
cable into a USB port.
4
Power Adapter
Power Cord
Figure 4
USB Power
Cable
Channels
Figure 5
Figure 6