in-lite FISH EYE LOW Manual De Instrucciones página 8

EN
Contents
1x FISH EYE LOW/HIGH (WW) 12 V / 5 W
1x ground stake
1x stainless steel ring
3x fixing screws
1x Easy-Lock
1x Torx key
Material
Stainless steel, impact-resistant polycarbonate
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Use
This fixture can be used in two ways:
With top reflector
Suitable for above-ground lighting in the yard or to mark a pathway,
drive or patio.
Without top reflector
Suitable as a spot light to illuminate special places in the yard. Use the
360° rotating light unit light unit for this. To direct the 'Fish Eye', you
must first slightly loosen the three screws of the top plate. Turn the eye
to the desired position and then fix it in place by tightening the screws.
Attention! Do not over-tighten the screws; only tighten them enough to
fix the eye in place.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life (about 25,000 hours) and a high light output and their
power consumption and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.