in-lite FISH EYE LOW Manual De Instrucciones página 9

EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
The fixture is delivered ready assembled and with a top reflector. To
use without the top reflector loosen the three Torx screws and replace
the top reflector with the stainless steel ring supplied.
Step 1
The fixture can be mounted on a hard surface using the screws sup-
plied or in soft surface using the ground stake supplied. The ground
stake is easily fixed by screwing it in the underside of the foot of the
fixture.
When using on a hard surface first remove the black ground plate from
the foot of the fixture by loosening the Torx screws. Next, fix the plate
to the surface using the screws supplied. Then place the fixture back
onto the ground plate and tighten the Torx screws.
Step 2
Join the Easy-Lock connector to the main cable. (Fig. 1)
a. There are two cable ducts. The duct with the narrowest slot is suit-
able for the 14/2 and 10/2 main cable. When using the old (thick)
10/2 cable, you should use the duct with the wide slot.
b. Clamp the correct cable duct on top of the main cable. There
should be no space left between the cable and the duct.
c. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
d. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 3
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 2)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.