Tripp-Lite PDUMV15 Manual Del Propietário página 2

Installation
1A
Zero U Rack Configuration. Attach the three mounting clips
supplied with the PDU to the rack enclosure using the included
hardware. The mounting clips should be attached along a
vertical plane at equidistant points which roughly correspond
to the center and ends of the PDU. The exact mounting
configuration may vary depending on the rack and enclosure. If
possible, use pre-existing mounting points within the
enclosure.
1B
Wall or Under-Counter Configuration. Attach the three
mounting clips supplied with the PDU to a wall or similar flat,
secure surface using the included hardware. The mounting
clips should be attached along a vertical or horizontal plane at
equidistant points which roughly correspond to the center and
ends of the PDU. If possible, use pre-existing mounting points.
WARNING: Do not attempt to mount the PDU with the
outlets facing downward; the mounting clips are not
designed to support the weight of the PDU in that manner.
1C
Zero U Rack Configuration (Mounting Buttons). Attach the
included mounting buttons to the PDU. Position the PDU as
desired in the rack enclosure, align the buttons with the rack
mounting slots, and slide the PDU into position.
Note: Regardless of configuration, the user must determine the
fitness of hardware and procedures before mounting. The PDU
and included hardware are designed for common rack and rack
enclosure types and may not be appropriate for all
applications.
2
Attach the PDU to the mounting clips. Using an assistant,
place a rear corner of the PDU on the inside edge of the
mounting clips, pivot the PDU toward the alternate inside edge
and snap into place.
3
Attach the input plug of the PDU to a grounded outlet.
Insert the plug directly into a grounded outlet that does not
share a circuit with a heavy electrical load (such as an air
conditioner or refrigerator).
4
Attach equipment to the PDU. Do not exceed the load rating
of the PDU. The total electrical current used by the PDU will
be displayed on the digital meter in amperes.
5
Optional Installation (Models PDUV20 & PDUMV20). The
PDU includes an adapter that converts the L5-20P input plug
to a 5-20P input plug. The adapter is optional; the PDU will
work properly without connecting the adapter.
14-02-334-933043.indd 2
1A
1B
1C
2
3
3
4
5
2
PDUMV15 and
PDUV15
PDUV20 and PDUMV20
PDUV20 and PDUMV20
3/26/2014 11:52:08 AM