pico Technology 2000 Serie Guía Rápida De Inicio página 6

PicoScope 2000 Series Oscilloscopes and MSOs
WARNING
To prevent injury or death, use the product only as instructed and use only
the accessories that have been supplied or recommended. Protection provided
by the product may be impaired if used in a manner not specified by the
manufacturer.
Maximum input ranges
Observe all terminal ratings and warnings marked on the product.
WARNING
To prevent electric shock, do not attempt to measure voltages outside of the
specified full scale measurement range below. Full scale measurement ranges
are the maximum voltages that can be accurately measured by the instrument.
Overvoltage protection ranges are the maximum voltages that will not damage
the instrument.
Full scale
measurement
range
±20 V
WARNING
Signals exceeding the voltage limits in the table below are defined as
"hazardous live" by EN 61010. To prevent electric shock, take all necessary
safety precautions when working on equipment where hazardous live voltages
may be present.
±70 V DC
WARNING
PicoScope 2000 Series oscilloscopes are not designed to measure hazardous
live signals as defined by EN 61010. To prevent electric shock, do not attempt
to measure voltages outside of the limits shown in the table above or the
specified full scale measurement range, whichever is lower.
WARNING
To prevent injury or death, the oscilloscope must not be directly connected to
the mains (line power). To measure mains voltages, use a differential isolating
probe specifically rated for mains use, such as the TA041 listed on the Pico
website.
CAUTION
Exceeding the overvoltage protection range on any connector can cause
permanent damage to the oscilloscope and other connected equipment.
2
Input channels
±100 V
Signal voltage limits of EN 61010
Copyright © 2006–2016 Pico Technology Ltd. All rights reserved.
Overvoltage protection (DC + AC peak)
Digital input
channels (MSO)
33 V AC RMS
Quick Start Guide
Signal generator
±50 V
±46.7 V pk max.
output
±20 V
DO231-5