Service And Maintenance; Technical Data; Data For Configuration With I/O Link - Aventics ST4-2P Serie Instrucciones De Servicio

6

Service and maintenance

Damage to the surface caused by solvents and
aggressive detergents!
The surfaces and seals could be damaged by aggressive
solvents and cleaning agents.
Never use solvents or aggressive detergents.
O
The ST4-2P sensor is maintenance-free.
Check the fittings and plug connections regularly.
O
Comply with the maintenance intervals and
O
specifications for the entire system.
7 Disposal
Dispose of the ST4-2P sensor in accordance with the
currently applicable regulations in your country.
8 Data for configuration with
I/O link
Service data, see tables
Physical layer
SIO mode
Min. cycle time
Speed
Process data width
Process data
The sensors with I/O link have 2-bit process data in bit 0
and bit 1.
Access Data
R 1 byte
RW RW RW RW
Bit 7 Bit 6 Bit 5 Bit 4
Bit 7 to 2: reserved
Bit 1 to 0: 0 = inactive, 1 = active
Direct parameter page
Manufacturer ID:
Device ID:
NOTICE
4 .
Yes
2,3 ms
38,4 kBaud (Com 2)
2 Bit (frame typ 2.1)
Data type Default
UINT8 0
RW RW RW
Q2
Bit 3 Bit 2 Bit 1
001F hex
ST4-2P 0021505
AVENTICS | ST4-2P | R412012414–BAL–001–AE
9

Technical data

Detection range
Electric version
DC supply voltage
Residual ripple
Voltage drop
Power consumption
(not actuated)
Continuous current
Hysteresis
Reproducibility
EMC
Switch output
Output function
Connection type:
Line
Line with plug (4-pin)
Interface
Protection class
Wire break protection
Short circuit resistance
Reverse polarity protection
Switch-on pulse suppression
Shock/vibration load
Housing material
Ambient temperature
1)
Based on the operating voltage
2)
At a constant power supply and ambient temperature
RW
Francais
Q1
Bit 0
1 A propos de ce mode
d'emploi
Ce mode d'emploi contient des informations importantes
pour installer et utiliser le capteur ST4-2P de manière sûre
et conforme.
Lire ce mode d'emploi complètement et en particulier le
O
chapitre 2 « Pour votre sécurité » à la page 7, avant de
travailler avec le capteur ST4-2P.
6
0 to 50 mm
DC 4 (wire)
12 to 30 V
≤
1)
10 %
≤
2,2 V
≤
15 mA
≤
100 mA
1,0 mT
≤
2)
0,1 mT
EN 60 947-5-2
PNP
Make contact function
2 m PUR, 3 m PUR
M8, PUR
With/without I/O link
(depending on model)
IP67
Yes
Yes
Yes
Yes
30 g, 11 ms/10 to 55 Hz,
1 mm
PA
–20 to +75 °C