Measurement; Adjusting The Focus Of The Internal Display; Measuring - Nikon COOLSHOT 40 i GII Manual De Instrucciones

Measurement

Caution — Controls, adjustments or usage of procedures other than those specified herein may produce
negative effects or damage to your health due to laser radiation.
• Before measuring, confirm each menu setting by referring to "Changing the measurement display mode"
and "Changing the distance display unit".
„ Adjusting the focus of the internal display
„
If the internal display is difficult to see, adjust the focus with the following
procedure.
1. Press the PWR button to turn on the power.
2. Look through the eyepiece and rotate the diopter adjustment ring until the
internal display comes into focus.
„ Measuring
„
1. Press the PWR button to turn on the power.
• If you do not operate the button for about 8
seconds, the power turns off automatically.
Immediately after power-on
3. Press the PWR button to measure.
After measurement, the result is displayed for approx. 8 seconds, then power automatically turns off.
Press the PWR button while the power is on to measure again.
2. Aim at the target.
Position the center of the target mark on the
target.
Diopter adjustment ring
Target mark
En
Es
Fr
De
It
Sv
Nl
Ru
Pl
Fi
Cz
Ro
Hu
Kr
15