Remote Control Operation; Carrying Handle - Philips FC9259 Manual Del Usuario

English
8
 Reattach the battery compartment lid (1) and fasten the screw with a screwdriver () (Fig. ).
The appliance is now ready for use.
preparing for use
hose
1 To connect the hose, push it firmly into the appliance ('click') (Fig. 5).
 To disconnect the hose, press the release button (1) and pull the hose out of the appliance
() (Fig. 6).

remote control operation

- The control panel has three buttons with which you operate the vacuum cleaner.
- Types without display: the infrared-active light flashes when you press a button on the control
panel (Fig. 7).
- Types with display: when the filter-cleaning reminder symbol on the display flashes, you have to
clean the filter (Fig. 8).
- Types without display: when the filter-cleaning reminder light on the remote control flashes, you
have to clean the filter (Fig. 9).
- Specific types only: The control panel has a display that gives information about the suction
power and the battery status. It also tells you when to clean the filter (Fig. 10).
Ergonomic advice
postureprotect handgrip
- The unique PostureProtect handgrip is ergonomically designed for 2-handed use to prevent you
from placing your hand on the lower part of the tube.We recommend that you use the
PostureProtect handgrip to prevent bending your back, but if you do not find it comfortable to
use, you can remove it. In this case, follow the instructions in section 'Removing the
PostureProtect handgrip' in chapter 'Troubleshooting'.
- Do not place your other hand on the tube. You twist and bend your spine when you do so,
which could result in serious back problems.
- Our ergonomist advises you to adjust the length of the tube so that the hand holding the
standard handgrip is at hip level. (Fig. 11)

Carrying handle

- If you need to carry the appliance, carry it in line with your arm to prevent twisting your wrist.
The carrying handle of the appliance is specially designed for this purpose.
telescopic tube
1 Attach the telescopic tube to the standard handgrip ('click') (Fig. 12).
 To disconnect the tube from the standard handgrip, hold the standard handgrip with one
hand. With the other hand, hold the telescopic tube with or without PostureProtect handgrip
(specific types only), press the tube release button (1) and pull the tube off the standard
handgrip (Fig. 1).
 To connect the tube to a nozzle, press the spring-loaded lock button on the tube and insert
the tube into the nozzle. Fit the spring-loaded lock button into the opening in the nozzle
('click') (Fig. 14).
 Adjust the length of the tube in such a way that the hand holding the standard handgrip is at
hip level (Fig. 15).
Tri-Active nozzle (specific types only)
The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors.