Basic Operation; Battery Operation - Denver DAB-42 Manual De Instrucciones

BASIC OPERATION

Settings Up
Mains
To run the radio from mains power follow the below instructinons.
1.
Connect the DC mains plug to the DC mains input socket on the rear of the unit.
2.
Connect the plug of the adaptor to a mains outlet and switch on.
Note: The DAB+ radio station list is stored in the memory and so the next time you switch on your radio on, the
station search does not take place.

Battery Operation

Follow the steps to install the 4 x batteries.
1.
Unclip the battery cover in the direction indicated on the cover
2.
Insert 4 x AA batteries in the sequency shown, observing polarity (+/-). The correct direction each
battery needs to be installed as indicated inside battery compartment.
3.
Refit the battery cover
Note: To run the radio on battery power you will need to switch off and disconnect the mains cable if connected.
Standby & Power Off Mode
1. Press and hold the Power/Mode button for 1 second to put the system into Standby mode.
2. Press and hold the Power/Mode button again for 1 second to turn the unit off. You can use this mode to
save battery power.
3. To switch back on just simply press the Power/Mode button.
Scanning for DAB+ stations
1. In DAB+ mode, press and release the Scan button to carry out a scan 'Scanning. will be displayed and
a progress bar will show the progress of the scan and the number of stations found during the scan will
also be displayed.
Storing a DAB+ station preset
Your radio can store up to 10 DAB+ stations in its preset memories for instant access to your favorite
stations.
Note: When you store DAB+ radio station presets, these do not overwrite your FM station presets
1. Tune your radio to the station that you wish to preset.
2. Press and hold the Preset button in the front of your radio. Preset Store <1: (Empty)>is displayed And
the Number is flashing. Or 'Empty if no previous station has been stored.
3. Use the Prev. or Next button to move to preset location that you would like to store the radio station to
(1-10)
4. Press and release the Select button to confirm your selection. The display will confirm Preset X stored,
where x' is the number of the preset (1-10).
Note: If there is already an existing DAB+ station stored under a preset, it will be overwritten when you store the
new station