Troubleshooting - Denver DAB-42 Manual De Instrucciones

TROUBLESHOOTING

Problem
No Power
Desired station not
found
The display is blank
I can hear a burbling
noise on some
stations
No sound
Reason(s)
The Power switch is set to OFF
Batteries are flat
Weak signal Station not available in
your area
This may occur if the broadcaster
changes the label of a service or
removes a label while tuned.
Battery power is low weak signal
Volume set to minimum
Solution(s)
Set the Power switch to the ON position
Replace the batteries or use mains power
Use the manual tune function
The unit will try re-tune. If not perform a new
scan
Replace the batteries or use mains power Try
re-positioning the antenna
Increase the volume level