Hilti DSH 600-X Manual De Instrucciones página 45

8.1 Transporting the product in a vehicle
WARNING
Risk of fire and explosion. If the product tips over during transport, fuel may run out of the fuel tank.
▶ Empty the product's fuel tank completely before packing and shipping it.
▶ Transport the product, as far as possible, in its original packaging.
WARNING
Fire hazard. Hot parts of the machine could ignite material lying about in the surrounding area.
▶ Allow the product to cool down completely before packing it away or loading it into a vehicle..
1. Remove the cut-off wheel.
2. Secure the product to prevent it falling over, thereby causing damage or fuel spillage.
8.2 Storing the fuel mixture
CAUTION
Risk of injury. As pressure may build up in the fuel tank there is a risk of fuel being forced out when the fuel
cap is opened.
▶ Always open the cap of the fuel tank carefully so that the pressure is relieved gradually.
▶ Store the fuel in a dry, well-ventilated room.
1. Mix only enough fuel for a few days' use.
2. Clean the fuel container occasionally.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, contact Hilti Service.
Trouble or fault
cut-off wheel slows down
or stops completely while
cutting
High vibration, wheel wanders
off the cutting line.
The diamond cut-off wheel
swings up and may jam.
*2136486*
Possible cause
Excessive cutting pressure applied
(cut-off wheel stalls in the kerf)
or pressure applied to the cut-off
wheel from the side.
The cut-off wheel is not correctly
fitted and tightened.
Wrong direction of rotation.
The forward section of the saw arm
is loose.
The cut-off wheel is not correctly
fitted and tightened.
cut-off wheel is damaged (or un-
suitable specification, cracked,
segments missing, bent, over-
heated, deformed, etc.).
The centering bushing is fitted in-
correctly.
Diamond cut-off wheel does not fit
correctly
Flange for diamond cut-off wheel
does not fit correctly
2136486
Action to be taken
▶ Reduce pressure when cutting
and guide the product in a
straight line.
▶ Check how it is fitted and the
tightening torque.
▶ Fit the cut-off wheel. → page 30
▶ Have the product repaired by
Hilti Service.
▶ Check how it is fitted and the
tightening torque.
▶ Change the cut-off wheel.
▶ Check that the diameter of the
arbor hole in the cut-off wheel
matches the centering collar
of the cut-off wheel centering
bushing.
▶ Use Hilti cut-off wheels.
▶ Verwenden Sie bei Wettbewerb-
sTrennscheiben den Flansch für
abrasive Trennscheiben.
English 37