Service Settings; Activate Factory Default Setting; Delete All Programmes; Updating Software - TechniSat DiGYBOXX HD CX Manual De Instrucciones

Automatic addition
The newly found programmes are added to the end of the Main Favourites list in unsorted order.
Manual sorting TV/ manual sorting radio
Here you will go directly to the menu Manage TV or radio lists.
Edit these lists as described above.
Back
The newly found programmes are retained only in the Total list

9.5 Service settings

You can access the factory default settings at any time. You can also, if the programme list has become ob-
solete through changes made by the programme providers, delete the programme
list completely and perform a new programme scan.
> Use the Menu key to call up the Main menu.
> Now use the arrow keys up/down to mark the menu line Settings.
> Confi rm by pressing OK.
The sub-menu Settings will be displayed.
> Now use the arrow keys up/down to mark the line Service settings.
> Confi rm by pressing OK.
The sub-menu Service settings will be displayed.

9.5.1 Activate factory default setting

If this function is called up, the factory default setting will be implemented, personal settings will be dele-
ted, and the installation assistant Auto Install will be started.

9.5.2 Delete all programmes

This function will delete all programme memory banks.

9.5.3 Updating software

You have the possibility to updating the operating software of your digital receiver
Note:
For the new software to be loaded automatically, the digital receiver must be set to stand-by mode.
The downloading procedure will be indicated by the message "LoAd" as well as the percentage of data
already downloaded. Do not interrupt this procedure by switching the receiver on or off .

9.6 Updating software by using USB interface

In addition to the automatic software update via satellite you can also update the software via USB interfa-
ce. Firstly, in order to conduct the update via USB interface you have to download the current software from
the Technisat website (www.technisat.pl).
In order to update the receiver via USB interface you need an easily available USB device.
> Format the USB device in the FAT32 fi le system.
94