Functional Description; Removing/Inserting The Battery - Milwaukee M18 FUEL Manual Del Operador

FUNCTIONAL DESCRIPTION

8
9
10
1. Lever arm
2. Carry hook
3. Feed collar
4. Cable hook
5. Handle release button
6. Telescoping handle
7. Lever arm collar
SPECIFICATIONS
Cat. No. ..................................................... 2871-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
No Load RPM ....................................................700
Module/FCC ID ..................... BLE113/QOQBLE113
Cable Sizes ........................................ 7/8" & 1-1/4"
Recommended Pipe Diameter ........................2"-8"
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, unlatch the battery door, push
in the release buttons and pull the battery pack away
from the tool. Close and relatch the battery door.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, unlatch the battery door and slide
the pack into the body of the tool. Make sure it latches
securely into place. Close and relatch the battery door.
1
2
6
7
8. ONE-KEY™ indicator
9. Forward/Off/Reverse
10. Battery door
11. Rear guide hose
connection
WARNING
may be hazardous.
Selecting the Proper Cable
Different size and types of cables are available for
different applications. Remove the protective tip
cover from new cables before use.
3
Cat. No.
48-53-2852 7/8" x 15' All Purpose Open Wind Sectional Cable
4
48-53-2851 1-1/4" x 15' All Purpose Open Wind Sectional Cable
48-53-2854 1-1/4" x 15' Heavy Duty Open Wind Sectional Cable
5
Cable Attachments for Use with
MILWAUKEE Coupling Cables
Cat. No.
7/8"
48-53-3830 48-53-4830 Straight Auger
48-53-3831 48-53-4831 Funnel Auger
48-53-3832 48-53-4832 3" Root Cutter
48-53-3833 48-53-4833 4" Root Cutter
11
48-53-3834 48-53-4834 6" Root Cutter
48-53-3835 48-53-4835 Small Opening Tool
48-53-3836 48-53-4836 Medium Opening Tool
48-53-3837 48-53-4837 3" Chain Knocker
48-53-3838 48-53-4838 4" Chain Knocker
48-53-3840 48-53-4840 Head Attachment Kit
CAUTION
diameter pipes.
Cable Attachment Installation
To install the attachment:
Snap the attachment coupler into the cable coupler.
Test the cable before inserting into the drain to make
sure the attachment does not fall off during use.
To remove the attachment:
Insert the pin key into the coupling hole and pull at-
tachment off of cable.
Connecting/Disconnecting Sectional Cables
Keep the cable couplings clean and lubricated. The
pin key must move freely and fully extend to secure
the connection.
To connect the sectional cables, slide the two cable
couplings together. Make sure the connection is secure.
1
To disconnect the sectional cables, insert the pin
key into the coupling hole and pull the cables away
from each other.
4
Only use accessories specifically
recommended for this tool. Others
Description
Description
1-1/4"
To prevent damage to the cable and
attachments, do not use in larger
2